The scorm for “Process Planning applied to CNC” was created. You can now run it via learning platform (moodle – Fundamental Knowledge). A first draft of the trainee workbook (English not revised yet) is available too, is just to give you an idea of how it looks like.
Both powerpoint and workbook will be discussed during our on-line meeting in order to agree on it format and design.
Hope you have had a wonderful Christmas time.
This post is to inform you that is available a first version of a dynamic powerpoint for the content “Process Planning applied to CNC”. Is still under development and the idea is just to show how it looks like. The “scorm” will be available over next week.
A first version of the trainee booklet/workbook is almost finished and will be shared quite soon.
. Minimum requirements: Powerpoint2013
. Mouse click only!
Wishing you all a Happy New Year!
Just to inform you that a template for the Process Plan Data Sheet & Tooling Data Sheet is now available for your analysis and contributions.
The Tooling Data Sheet already includes the suggestions proposed by Carlos and Jon.
The Process Plan Data Sheet was inspired in different documents, including those shared by Dave in Stuttgart.
As discussed last Wednesday, the goal is to have both templates validated until the end of next week.
Have a nice weekend
Hope all is well with you.
We have been developing with Risto a template for the “Tooling Data Sheet” that is now shared for your analysis and approval, over the next week will be shared a proposal for the “Process Plan Data Sheet” too. Since both sheets are the base for the development of the practical exercises, it will be quite important to have an agreement before the next on-line meeting (2 of December).
Looking forward to get your comments and suggestion.
We are now sharing a first set of ideas for the unit 2 of learning outcomes. Unlike unit 1, this one is not complete yet, hope to finish until the next week. This work needs a joint analysis and revision but so far no comments or contributions were given regarding the unit 1. Despite the deadline of October, would be important to have a first revised version as soon as we can since the LO´s units are one of the references for the specifications work that we are currently developing.